HSRP sends hellos to multicast address 224.0. The other half must use the other virtual address as their gateway – 10.1. To achieve load balancing with this HSRP setup, half of the hosts in VLAN 100 must point to the first virtual address as their gateway – 10.1. Interface tracking enables the priority of a standby group router to be automatically adjusted, based on the availability of the router interfaces. The Need for Interface Tracking with HSRP HSRP can track interfaces or objects and decrement priority if an interface or object fails. Router(config-if)#ip address address netmask To view the HSRP information, use the following EXEC command: Router2# show standby. You want to see current HSRP information, such as which router is primary. What is the command to check HSRP status? Additional HSRP member routers transition from the listen state after the holdtime expires on the hello message. What happens when an HSRP active router fails? (Select two.) The HSRP standby router becomes the active router after the holdtime expires on the hello message. What happens when an HSRP active router fails? Note down and check the STP topology on each VLAN and check for STP failure. Disconnect the port that must not source the host MAC address and check for HSRP stability. How many routers can participate in HSRP?įind the correct source (port) of the MAC address in which the error message reports.
What is the command to check HSRP status?.
0 kommentar(er)
